ElectraStim Spare Replacement Cable

A fresh lead for your stim box

The ElectraStim spare replacement cable is an electro stim lead: one end plugs into your ElectraStim stimulator, the other splits into two 2 mm pins for your electrodes. It carries the current to the loops, pads or probe on your cock, balls or ass.

Best forGuys with a worn lead, or a spare channel to wire up.

Sunday, stim box on the kitchen table by the coffee, and the old lead finally admits it's done: crackle, nothing, crackle. The spare clicks in, the pins go into his cock loops, and the dial stays at zero until he's finished his toast.

• Resilient tinsel wire, made for session after session of plugging and coiling
• Two 2 mm pins fit every ElectraStim electrode and some other brands
• A second lead wires a second channel: one on your cock, one in your ass

How to connect an electro stim cable

1. Stimulator off, dials at zero: push the right-angle plug into a channel socket.
2. Bipolar probe or toy: both pins go into it. Unipolar loops or pads: one pin each, say one at the base of your cock and one around your balls.
3. Place the electrodes first, then switch on and raise the level slowly. Retire a lead that's kinked, nicked or cutting out.

Everything else in that box is allowed to bite. Not the cable.

Care

Safe play needs cables in good working order, so check the lead for kinks and nicks before each session and replace it when it wears.

SafetyNever use electro-stim above the waist or across the chest, and skip it if you have a pacemaker or a heart condition. Always check your electrode's instructions before using it with other brands.